|
|
 Starting in the center of...  Starting in the center of the seat, hog-rings were used to hold the new seat cover to the original frame. Be sure to keep the seat cover snug while working toward the outer edges of the seat with the hog-rings.  The recovering process was...  The recovering process was repeated on the front seat and seatbacks, and our seats were ready to re-install in the car.  Prior to installing our recovered...  Prior to installing our recovered seats, we cleaned our seatbelts with soap and water and bolted them in place.  The rear seatback was held...  The rear seatback was held in place by these brackets top and bottom...  ...then the lower seat was...  ...then the lower seat was slid into place and held there by similar brackets.  After locating the front seat...  After locating the front seat mounting holes from underneath, we used a soldering iron to melt holes in the carpet for the seat retaining bolts. This not only makes a nice hole, but keeps the carpet from fraying around the hole.  We installed our front seat...  We installed our front seat in the car, giving our interior a finished look and getting us one step closer to completing the project.  With our new carpet, seats,...  With our new carpet, seats, and interior components installed, you can see the dramatic difference in our car's interior. We did spend a few dollars to get our car looking this good, but we also saved a significant amount by doing most of the work ourselves.  You too can greatly improve...  You too can greatly improve the appearance of your car's interior with a little effort. As shown here, the results are certainly worth it!
|